A7V266-E with OCZ PC3000

[deadf00f]

I cant seem to get good performance out of my pc3000!

I had 2 x 256 pc2400 memory and I was able to run from cl2 @ 133 to cl2.5 @ 150. Now I have this ocz pc3000. I can get cl2 @ 133 and even cl2 @ 150 but that's it! I cant get past 150

I started reading post here last week and found out people not recommanding ocz pc3000 (wish I had known this forum before :) )

So... Is there any way I can get closer to 160 mhz with ocz pc3000?

I admit there are a few bios parameters I havent tried changing, Bank Interleave, DDR 1T/2T, etc. All of these are set at AUTO. Also the I/O voltage was set by default at 2.8 volt. Isnt this suppose to be 2.5?

And what if I dump it all that and get the new KingMax PC2700? Would my A7V266-E be able to handle it?

Ok, enough questions! Thanks for reading. Any help is appriciated


deadf00f

[OC-Master]

PC3000 is supposed to run at 366MHz @ CL2.5, then you would get awesome performance.

but with n-force, you should settle for 333MHz CL2! since the n-force starts to give out passed 333fsb.