celly 366@733

[saaya]

got a celly 300a and celly 366 from a friend , nice thingie to test my w/c setup:p board=asus p2b. but if i set fsb to anything over default it wont boot.

i remembered that you can oc them by pin insolation. pin b21 as far as i remember. my p3 700E runs 933@default voltage with pins b21 and a14 insulated.

if i insolate those pins on my cellys , could they run 133 fsb?:D
we'll se:beer:

366@100fsb=550:D
366@133fsb=733:eek: i know this wont work, but can anybody explain to me why?

[saytan]

they dont work past about 600, the architechture just wasnt capable of it without supercooling

[saaya]

so it doesnt run on fsb over 140?

[Yodums]

No

[saaya]

:beer: 140 what am i saying?:beer:

112fsb highest ive seen so far on this chip....

[saytan]

an exceptional 300 might just squeeze to 133fsb if you rammed a lot of volts up it :D

[deez]

Originally posted by saytan
an exceptional 300 might just squeeze to 133fsb if you rammed a lot of volts up it :D

I seriously doubt it...the limit for mendocino core chips is about 600. According to CPU database average OC speed is 474

[saytan]

which is why it would have to be an exceptional one

[Max the Axe]

366@550 if ur very lucky, more if u've got superkriogeniccoolingsystem

[saaya]

the 366 doesnt even get warm if i oc it.... it didnt even run 100fsb. as the next lower setting is 85 or so, 480mhz is the highest i got it to.:confused: somebody know a tool like cpufsb or cpucool that allows you to set fsb to 1 or 5 mhz increase?

ill try to hit the 300a this weekend. what do you think itll go to?

[Snarkey]

From what I've read, I was one of the lucky ones. had a cel366 @ 550 for 6 months. You're right about the temps. I never had a problem and just went with generic stuff. Used the same board I have a Cel 566@950.

[saaya]

yeah, but you have the p2b-f. yours allows fsb increases by 1mhz and voltage settings,right? mine doesnt. do you think i need to raise voltage? i can still isolate the pins to get v up to 3v....i bet it would run hot then! what voltage did yours run @?

[Snarkey]

Core was at 1.8. I settled on that. I had (and am still using) an asus 370-dl sloket. I set the fsb through the board and the voltage from the sloket.