hafa
04-23-10, 06:49 PM
Just another last-ditch trick for drives with fatal issues...
A customer recently brought in a drive that would not boot with data that they'd prefer not to lose. After doing the freezer trick and impacting the bearings, the best I could get was a squeeky groan followed by silence.
Since the customer didn't care enough about the data to spend for a data recovery center, I thought, "what the heck" and connected the drive (a notebook drive) to 7V, rather than 5V. Low and behold, it spun up with minimal complaint and I was able to copy off the data.
Disclaimer: Use this trick at your own risk; you're equally likely to fry the drive electronics or motor as get data back, but it may be worth trying for "damn the torpedoes (http://en.wikipedia.org/wiki/David_Farragut)" situations.
A customer recently brought in a drive that would not boot with data that they'd prefer not to lose. After doing the freezer trick and impacting the bearings, the best I could get was a squeeky groan followed by silence.
Since the customer didn't care enough about the data to spend for a data recovery center, I thought, "what the heck" and connected the drive (a notebook drive) to 7V, rather than 5V. Low and behold, it spun up with minimal complaint and I was able to copy off the data.
Disclaimer: Use this trick at your own risk; you're equally likely to fry the drive electronics or motor as get data back, but it may be worth trying for "damn the torpedoes (http://en.wikipedia.org/wiki/David_Farragut)" situations.