Re need help wire trick

[peter p]

I finally got it, the Cel 850 @ 1.13 gigs. I just had to raise the voltage up from 1.70 default to 1.90 (vid2 to vss). I installed MBM and it's telling me that my cpu temp is at 50 degrees celcius at idle, but my hardware manager in the bios is telling me it's idling at 34 degrees celcius. Which do I believe? Before I overclocked, MBM did the same thing it said it was at 47 degrees celcius at idle and sometimes jumped all the way up to 80 degrees and this was before I overclocked. I think MBM is not reading the sensors properly. I am going to install a better heat sink on the global wind before I start doing any more testing.
I want to thank all the guys that helped me on my posts:)
Thanks

[takiwa]

In the pull down menu for your sensor in the MBM menu, is there more than one sensor for you to choose from? You may be monitoring the wrong one...I also apologize for the confusion earlier about the voltage, glad to hear you got it working right.

[peter p]

Yeah, it's for one more sensor, but I don't know what it is. The temp on that sensor is 108 celcius on MBM.