How to make startup hole for nibbler

[earthdick]

I just got my nibbler at the "love" shack and I am ready for my first mod. I measured out the two 120mm blow holes where I want them and taped the fans on the inside to make sure everything is perfect. Now, how do you make the startup hole? I have an aluminum case.
Thanks.

[BinarySuperman]

lol, what i did was i used a dremel with the drilling bit and i drilled a hole then started moving it in circles so the hole would get big enough for the nibbler.

[earthdick]

Unfortunately, no dremel (yes, I know bad, bad, modder). Will a regular electric drill do the job with a large drill bit?

[BinarySuperman]

i tried that, i couldn't do it with a large bit, but use a drill with a small drilling bit and make a couple of them near each other and make one big hole, like 2cm x 2cm.

[earthdick]

Kewl, I'm off to the garage in the morning. Thanks.

[Jeniva]

use a drill...thats your best bet, use a nice sharp bit, and you can use a decent sized one...Just dont use an Auger bit :eek: