I bought a Thermaltake Armor A90 case and it's a bit different from what I have seen in the past.
Half of the points on the case that are threaded for those little screw/stud things are raised while the other half are not, requiering you to use those stud thingys. If I install it that way, then the motherboard is physically making contact with the case, but I see no other way to install it.
Are those studs just to give the case breathing room and the contact dosnt really matter?
You can see the raised spots in the pic, but they dont exist near the video card area.
Oh and I posted this here since I'm installing a UD3R board for my I7
Half of the points on the case that are threaded for those little screw/stud things are raised while the other half are not, requiering you to use those stud thingys. If I install it that way, then the motherboard is physically making contact with the case, but I see no other way to install it.
Are those studs just to give the case breathing room and the contact dosnt really matter?
You can see the raised spots in the pic, but they dont exist near the video card area.
Oh and I posted this here since I'm installing a UD3R board for my I7