Cool

[gerby123]

http://community.webshots.com/storage/1/v0/1/35/44/30913544vAESuZfZtZ_ph.jpg
cel 2 566@933.
this is the lastest. i just put on the 72w pelt. not bad. i may go for 1ghz. any tips before i jump into it? think the voltage would need to be higher?

how come this image thing isnt working!? there maybe that worked

[deathstar13]

would help greatly to see some temp info before i gave that advice. @load and your current voltage on cpu

[bobt17]

Welcome to the forums gerby123 :) here is that pic u were trying to post... i looked in the properties and found the url of the pic and copied it into my browser to see it so i could post it for ya :D

[Inteleron]

i posted a week or so ago almost about the same thing, i've got a celly2 633 @ 950 (100fsb) i'm not sure what motherboard your running but my system wasnt stable at this setting until i added a larger heatsink to the northbridge, and now its rock solid at 950mhz ... i definitly would say raise the voltage, thats my next step, i've got a 72watt pelt from be-cooling in the mail expected on wensday the 13th, and i'm going to try my luck w/ active northbridge cooling alittle Artic Silver 3, the be-cooling pelt, and some vid pin wrapping i was advised to do when i posted about squeezing out a little more mhz last week... the site is here:

http://www.hardocp.com/articles/intel_stuff/bumpvoltage.html

goodluck! Keep it Celeron! :D

[rivercom9]

Man thats pretty close to a 50% OC, and without multipliers? Or do the 566 Celeys ahve multipliers?