Power on LED Adapters

[Gresyth]

I just installed an ECS K7S5A mb and it has two pins for the Power on LED but my Case has a three pin plug for Power on LED.
Where can I get an adapter for this.

Also, my power button only does standby for power off. How do I get it to 'shut off the power' instead of going into Standby?

[Monaco]

you should be able to change how the power button works in your BIOS setup screen.

As for the LED- the only reason I can think of for it to have a 3 wire LED is because it is a dual-color LED. If so, you can basically pick a color and use it as a single-color, but it will take some soldering. Not too hard tho.

[Gresyth]

Maddman found the answer to the power switch. I have to hold it in untill the comp switches off.
See roomies are good for something....:D

As for the other I'll probably have to try to switch one of the wires to the center position.