Need help with ram from 1333 to 1866 timings plz!

[K-C1455]

Hi all

My System is:

M5A78L/USB3 Motherboard
FX-6100 AMD Bulldozer Processor
EVGA GForce 560TI superclocked Graphics
Kingston HyperX T1 6GB 1866 MHz Ram (Compliant with my Motherboard)

On boot my ram speed is reporting 1333mhz and I would like to set it to 1866mhz. What settings should i use as i am a worried about damage to my system if i enter wrong settings.

Thankyou
K-Class

[redduc900]

Enable XMP and select the DDR3-1866 profile.

[K-C1455]

Enable XMP and select the DDR3-1866 profile.

Hello and thanks for your reply

Iv looked through my bios and tbh im not sure where to start.
I can not seem to see a setting called "Enable XMP"
I am a total noob when it come to anything other than boot configuration :P

sorry to be a pain :(

[redduc900]

If your board isn't XMP capable, then you'll first need to change Memory Clock Mode to 800MHz (= DDR3-1600), then adjust the HT Reference Clock upwards from the default of 200MHz until the effective DRAM frequency = DDR3-1866.

[sumonpathak]

Change the Memory Clock mode to 800Mhz and then push your FSB to 233-234 Mhz from stock 200Mhz..since its an FX clocking shouldn't be a problem.

[K-C1455]

Change the Memory Clock mode to 800Mhz and then push your FSB to 233-234 Mhz from stock 200Mhz..since its an FX clocking shouldn't be a problem.

I set FSB to 233 and Memory clock to 800 and the system would not boot up.

[sumonpathak]

err....what multiplier were you using?
try lowering it a notch..

[K-C1455]

Been Busy with work past few days so have not had chance to carry on with setting up my ram speed.

I will have a go at dropping my multiplier a notch and let you know what happens.