I've run this board with 1.8A at 133FSB (1.75V) for the last week, now i'm getting instability issues e.g. suddenly the screen in Windows XP goes gray and i need to press control+alt+del so the whole GUI shows backup again. Also i get corruption of data in Wolfenstein i.e. my name changes in multiplayer to numbers, and sometimes it goes back to the main menu of the game for no reason.
I've put it back to default settings now i.e. 1.5V 100FSB, and i've still got the same issues!!!
I've used memtest and run it for 3 hours to check the memory, and its alright.
It does this in Wolfenstein in both of my hard drives, so i don't think its a hard drive issue.
Now the only thing i have left is a power supply problem, but i'm not sure if this would cause corruption of data??? Its an Aopen 300W psu: +5V - 4.92v 12V - 11.86v.
My voltage at 1.5V is 1.44V and it decreases by a further 0.4V under load.
What do you think is going on here?
I've put it back to default settings now i.e. 1.5V 100FSB, and i've still got the same issues!!!
I've used memtest and run it for 3 hours to check the memory, and its alright.
It does this in Wolfenstein in both of my hard drives, so i don't think its a hard drive issue.
Now the only thing i have left is a power supply problem, but i'm not sure if this would cause corruption of data??? Its an Aopen 300W psu: +5V - 4.92v 12V - 11.86v.
My voltage at 1.5V is 1.44V and it decreases by a further 0.4V under load.
What do you think is going on here?