idea....to prevent condensatoin.. i thnk it should work

[Lt. Max]

to get rid of condensatoin or protect smth from it you could... use electrical tape! u could mask whatever u wanna protect wit the tape and many layers just in case even so no water goes thru no electricity gets to water.. :D would it work? i think it would i never saw nething bout it tho.. but if condensation does get on it i dunno where it would go so... wait i do, u could make wit tape a little gutter that goes into a pipe and all the water pipes go into some container on bottom of ur case . tadaa :D.. late night ideas, dunno prolly will b proven wrong

[64Thunderbolt]

I wouldnt use elect.tape, it wont hold. Id use something like those oversized Slurpee straws and run it down to a container or something...

my 2 cents...

Charlie:beer:

[Tactics]

The continued heating and cooling of pelters or anying cooling device would eventually cause the tape to fail. Not to mention, everytime I try to use electrical tape in extreme temperature conditions, it does not stick worth a damn.

Tactics

[kevin_bouchard]

that would be alot of tape, foam would work alot better because its less dense so it will insulate it better than electrical tape, i did though cover my pipe insulation with electrical tape and it worked good. And Tactics i had a roll that did work good under extreme cooled temps(around -20c) but the surface has to be clean and no condensation on the surface for it to stick. Unfortunately i dont know what brand it was.

[stool]

You can use polyurethane adhesive, or go to an electrical store and get some comformal coating. Neither costs much, and will seal components just fine.