- Joined
- Jun 23, 2002
- Location
- Upland, California
Hello
Does anybody know if running a DDR333 module at 2.8 volts would damage it? The reason I ask is because I just purchased a 512MB DDR333 (CAS 2.5) Samsung module. If I set all the timings to autodetect (SPD) the ram seems to run fine at whatever voltage the bios sets it to, but if I change the timings to 2.5(cas),2,5,2 then i get all sorts of crashes unless i adjust the voltage to 2.8 volts. Am I burning up my memory by doing this?
thanks.
Does anybody know if running a DDR333 module at 2.8 volts would damage it? The reason I ask is because I just purchased a 512MB DDR333 (CAS 2.5) Samsung module. If I set all the timings to autodetect (SPD) the ram seems to run fine at whatever voltage the bios sets it to, but if I change the timings to 2.5(cas),2,5,2 then i get all sorts of crashes unless i adjust the voltage to 2.8 volts. Am I burning up my memory by doing this?
thanks.