- Joined
- Jul 2, 2002
- Location
- nottingham england
below is the new akasa ak370 copper cooler.
It's a single copper block with fins machined from it.
after making the pinfin block from the ak350 (still testing that for leaks) i had this idea.
the idea is to remove some of the fins apart from the part over the core and cover again with acrylic and use a rubber o-ring to seal. should be easy to make
i put 3 in's and 2 out's but i think 2 in's would be ok.
i should be able to use the hold down without any changes.
what do you guys think.
Myarse
It's a single copper block with fins machined from it.
after making the pinfin block from the ak350 (still testing that for leaks) i had this idea.
the idea is to remove some of the fins apart from the part over the core and cover again with acrylic and use a rubber o-ring to seal. should be easy to make
i put 3 in's and 2 out's but i think 2 in's would be ok.
i should be able to use the hold down without any changes.
what do you guys think.
Myarse