- Joined
- Apr 4, 2003
- Location
- Glastonbury, CT
The Lian-Li PC-65's top blow hole is a damn stamped square! It doesn't lend itself to pretty cutting. Should I just hack it with a dremel cutting wheel as good as I can and stick a grill on top and maybe use some rubber moulding around it (hard for a square)?
I don't want to cut a larger 120mm hole with the dremel; sounds like too much work - prefer to stick with 80mm.
I was wondering if simply adding a fan spacer (another hollowed out fan) between the blowfan and the factory stamping will have any effect to warrant not cutting it to keep it pretty and effective?
I don't want to cut a larger 120mm hole with the dremel; sounds like too much work - prefer to stick with 80mm.
I was wondering if simply adding a fan spacer (another hollowed out fan) between the blowfan and the factory stamping will have any effect to warrant not cutting it to keep it pretty and effective?