- Joined
- Jun 11, 2005
- Location
- Hastings MI
Hey so I'm hooking up an old mobo I have to make an snes box however I'm running into a slight issue.
This is what the pins on the mobo look like (bad pic but you can get the jist)
https://plus.google.com/u/0/photos/114754297113775875212/albums/5736539988283795217
The wires I have from the case are, I have a "Power SW" (blue/white), "Reset SW" (blue/white), "HDD LED" (red/white) and separated "Power LED+" (green) and "Power LED-" (White)
Anyway the issue I'me having is that the manual (link below) has a different pin set up (page 1-26) but its the same mother board so I'm a bit confused as where I need to plug these in at
http://dlcdnet.asus.com/pub/ASUS/mb/sock754/K8V-MX/E2335_K8V-MX_h.pdf
This is what the pins on the mobo look like (bad pic but you can get the jist)
https://plus.google.com/u/0/photos/114754297113775875212/albums/5736539988283795217
The wires I have from the case are, I have a "Power SW" (blue/white), "Reset SW" (blue/white), "HDD LED" (red/white) and separated "Power LED+" (green) and "Power LED-" (White)
Anyway the issue I'me having is that the manual (link below) has a different pin set up (page 1-26) but its the same mother board so I'm a bit confused as where I need to plug these in at
http://dlcdnet.asus.com/pub/ASUS/mb/sock754/K8V-MX/E2335_K8V-MX_h.pdf