- Joined
- Jun 21, 2001
Welp, the title pretty much covers what I am interested in finding out. What pump would be best for this board?
I was originally thinking of going side by side (split the line and rejoin), but after a bit of reading, think I will be going with one after the other. Odds are it shouldnt effect the temps too much.
The blocks are Maze 3's. Good sized heater core, will be putting a shroud on with more than likely a 120 fan, possibly a few 80's in a square figure. Yes the core is large enough to have them sit side by side and an identical set on top of the other.
1/2" ID tubing.
The only question I am pretty unsure of, is which pump would be the best for this?
There will be minimal lift worries in this setup. I have a huge case, 3 foot tall one, the core and pump will be on the top leading down to the blocks which will be within a foots distance down and back up.
I was originally thinking of going side by side (split the line and rejoin), but after a bit of reading, think I will be going with one after the other. Odds are it shouldnt effect the temps too much.
The blocks are Maze 3's. Good sized heater core, will be putting a shroud on with more than likely a 120 fan, possibly a few 80's in a square figure. Yes the core is large enough to have them sit side by side and an identical set on top of the other.
1/2" ID tubing.
The only question I am pretty unsure of, is which pump would be the best for this?
There will be minimal lift worries in this setup. I have a huge case, 3 foot tall one, the core and pump will be on the top leading down to the blocks which will be within a foots distance down and back up.