Morvak
Disabled
- Joined
- Jun 20, 2007
I applied a thin line to the CPU like the AS5 website says.
Then I applied the same kind of thin line to the bottom of the TR 120 extreme.
Is this too much ? Can too much hurt?
I twisted the TR 120 a few degrees left and right as it was being mounted to make sure any air pockets were gone and to spread out the AS5 slightly.
I'm not too concerned but just want to make sure I didn't goof up.
TIA!
Then I applied the same kind of thin line to the bottom of the TR 120 extreme.
Is this too much ? Can too much hurt?
I twisted the TR 120 a few degrees left and right as it was being mounted to make sure any air pockets were gone and to spread out the AS5 slightly.
I'm not too concerned but just want to make sure I didn't goof up.
TIA!