Hi there...
i have the following problem...
i tried to install an AthlonXP 1700+ on my board after i 'installed' the new BIOS.
I forgot to set the jumper to 133MHz since i had a B Athlon before...
I powered on the system and it booted just fine...with 1100MHz though (11x100). Since it is a 1700XP i turned the system off and changed the jumper to 133. Then i booted and NOTHING happened....i mean the fans were rotating and the hard disks went on but no beeping of the board....
so i changed it down to 100 again and nothing happened...i put on my old proc and everything was fine...i tried the AthlonXP a few times but it never worked...
can anyone help me....or has made similar experiences or runs an XP1700+ on his Iwill board?
Thanks in advance
k-motion
i have the following problem...
i tried to install an AthlonXP 1700+ on my board after i 'installed' the new BIOS.
I forgot to set the jumper to 133MHz since i had a B Athlon before...
I powered on the system and it booted just fine...with 1100MHz though (11x100). Since it is a 1700XP i turned the system off and changed the jumper to 133. Then i booted and NOTHING happened....i mean the fans were rotating and the hard disks went on but no beeping of the board....
so i changed it down to 100 again and nothing happened...i put on my old proc and everything was fine...i tried the AthlonXP a few times but it never worked...
can anyone help me....or has made similar experiences or runs an XP1700+ on his Iwill board?
Thanks in advance
k-motion