Results 1 to 2 of 2
07-01-02, 02:25 PM #1
can i use the Corb with this card?
i will soon want to replace the hs on my msi G3Ti200 but im not sure if i will get attaching the Corb with the holes on the pcb.
i need to buy it online so i need to know this before.
i want help from ppl using the same card or ppl who have any comments about the picture below.
this is the back side of my cards pcb.
note there r four extra holes besides the two the stock hs uses.
07-01-02, 05:45 PM #2
according to thermaltake the pins are 54mm apart (5.4cm) + or - 0.5mm. it shows that on this page and there is also a .pdf file that you can download that says the same thing.
hope that helps.Mobile XP2500@2700MHz 208x13 @2.0V†††††††Dell Dimension 8100 P4 1.3
Abit NF7-S, 1024MB Corsair XMS3200††††††††††512MB PC800 RDRAM, T.B. Santa Cruz
ATi Radeon X850XT, Klipsch PM 5.1†††††††††††AIW Radeon 9800, 17" Trinitron
Dangerden RBX, 47c load, Dell 2005FPW†††††††Altec Lansing 4.1, THX certified