Anyone know what this means?

DSHELL caused a general protection fault
in module _MSTEST.EXE at 0004:000033c6.
Registers:
EAX=34373e67 CS=2ac7 EIP=000033c6 EFLGS=00000202
EBX=17c70000 SS=3e67 ESP=000035d4 EBP=000035e8
ECX=00000000 DS=3e67 ESI=00000000 FS=3e6f
EDX=00030000 ES=3e67 EDI=00003be0 GS=0000
Bytes at CS:EIP:
ff 1d 83 c7 06 46 39 36 26 1d 7f ed ff 36 bc 0c
Stack dump:
00000000 00000000 00002bfb 00013e67 3e67a753 357a362b 48562ac7 03660000 2aa62a97 3e6704d4 0556362f 48562ae7 48560000 0f2f04da 362204da 50d40f2f

Clearly its an error, I know that much, but what's it pointing to as the problem? I get this error when I try to install software for my "Grab-It" device (a cheap knock off of the old "Snappy" thing). You plug the box into your parallel port and then you put an RCA cable coming from a camcorder / vcr / whatever to the RCA port on the side and it lets you take snap shots from whatever the source is and save the pics digitally. I've installed it before without problem but I hadn't tried installing it since my last system re-install. I'm using 98fe if that helps. Anyone?

You may want to give this a try eobard...Add the following line to the [Compatibility] section of your WIN.INI file:

DSHELL=0x00400000

Restart your computer, try reinstalling your software...then remove the DSHELL line from your WIN.INI file.

I'll give it a shot, but I've installed the same stuff time and time again without any modifications needed.

That did it. I got an error at the very end of the install but that doesn't matter because it was good enough to install the stuff I wanted. Thanks.