- Joined
- Dec 13, 2002
(As this is my first post, I hope this is the right section for general MB mods)
I have a motherboard (MSI 6340M v.1) that was an early production model and as purchased was missing the jumper for selecting either 100 or 133 FSB, although the jumper was present in the diagram in the manual. Having looked at a later board that has this jumper installed, I can see exactly where it needs to go. I would like to connect the jumper connections with either solder or perhaps some kind of conductive paint or laquer, to set the FSB to 133.
There are 3 electrical contacts present. Does anyone know which of the 3 would need to be connected to close the "jumper"? (perhap's all 3?)
Would this require solder or would something easier and less permanent like conductive paint also work?
I have a motherboard (MSI 6340M v.1) that was an early production model and as purchased was missing the jumper for selecting either 100 or 133 FSB, although the jumper was present in the diagram in the manual. Having looked at a later board that has this jumper installed, I can see exactly where it needs to go. I would like to connect the jumper connections with either solder or perhaps some kind of conductive paint or laquer, to set the FSB to 133.
There are 3 electrical contacts present. Does anyone know which of the 3 would need to be connected to close the "jumper"? (perhap's all 3?)
Would this require solder or would something easier and less permanent like conductive paint also work?