• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Clamp for the EvO

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.
YGPM. The DTek clip will not work on the Evo because of the center inlet barb. Not meaning to insult your intelligence, but are you sure your board doesn't have any holes? They may be covered up by a heatsink. Here's a picture of the A7V333 from newegg's website, and it shows the 4 mounting holes on this board. I've circled them in yellow to make them more visible.

I'll get started drawing up a socket hold down clamp for the Evo, just in case.

a7v333.jpg
 
Back