Results 1 to 3 of 3
  1. #1
    Member secretweapon's Avatar
    Join Date
    Dec 2003
    Location
    Edmonton
    Posts
    645

    Will Mushkin L2s give me a better timing?

    How much imporvement can I expect from mushkin L2s without mods to my motherboard? I'm currently running 2.75v for DDR, 1.575v for cpu, AGP/PCI freq is set to auto, spread spectrum is disabled, performance acceleration mode for chipset = auto, DRAM idle timer = auto, DRAM Refresh mode = 7.8uSec. CPU temp idle = 39, load = 47 (See my sig for my current configuration)

    Upping the voltage to 2.85v (max) had no effect on timings. I ran memtest, sandra burn-in, 3dmark 2003, and played hours of max payne 2/CS without any problems at current configuration. However when i shut down windows xp it shows a couple of messages of programs is not responding & couldn't read a memory address It shuts down properly after that without problems.

    Thx for ur help!

  2. #2
    Member
    Join Date
    Oct 2003
    Location
    Finland
    Posts
    130
    The Mushkin lvl 2 would give better timings (2-2-2)but it would not necessarily allow you to increase your FSB.

    At 2.85V's they might be able to hold on to those timings at DDR453 but very likely you would have to make do with 2-3-2, and even that is not guaranteed since the spec is only 433.

    Turned out a rather inconclusive answer, shall I cancel this..
    Nah, at least I'll bump it for you.

  3. #3
    Member secretweapon's Avatar
    Join Date
    Dec 2003
    Location
    Edmonton
    Posts
    645
    All I want is some better timing, for some reason I can't get the kingstons to run at 5:4 without some serious error

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •