• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

50C and Below ok?

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

RavenOsU

Registered
Joined
Dec 15, 2003
Location
Spfd
Hey I have a Barton 2600+ and have recently OC'd it to 2.3ghz 11.5x200 (locked multi). I run at temps, under load, in the 40s and idle in the high 30s. Are these good temps considering im using an aluminum HS and 4300 RPM coolmaster fan?
 
Yea that is not bad with aluminum HS. If you were to go with a copper HS and maybe a fan with more CFM and Artic silver 3 you would get lower temps. Thermalright SLK-900a or slk-97 with the heat tubes is very nice aswell but a bit more pricy since it just came out.
 
Back