i just received some xtra NIc cards for my server
so i want to turn it into a router/firewall and dhcp server
(oh btw i want to put all this on my existing gentoo setup)
i want to set it up so
eth0 -- i get the line in from my cable modem
eth1 -- goes to the switch, all the computers will connect to the switch and will get IP from the dhcp server and route the internet connection through it
well basically i have no clue where to start
i know i need to add some modules to my kernel
but i dont know what software besides that i need, and how to configure it
--thanks alot
so i want to turn it into a router/firewall and dhcp server
(oh btw i want to put all this on my existing gentoo setup)
i want to set it up so
eth0 -- i get the line in from my cable modem
eth1 -- goes to the switch, all the computers will connect to the switch and will get IP from the dhcp server and route the internet connection through it
well basically i have no clue where to start
i know i need to add some modules to my kernel
but i dont know what software besides that i need, and how to configure it
--thanks alot