• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Quick questions about Bios Chipset ^^

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

DigiEgg

New Member
Joined
Aug 2, 2004
Hey guys!
Noobie here... please don't flame me...

I went in Advanced Chipset to see how I can make my graphics card run better...
Few questions!

Performence Acc. Mode is set to [Auto]
-Can I enable that with my system specs below?
-DRAM Idle Timer?
DRAM Refresh Rate?
Spectrum?

Also I don't understand the ratio on the FAN...
Q Fan I think is what it's called...
Higher the better?

Sorry... :bang head :bang head :bang head :bang head :eh?:
 
WELCOME TO THE FORUMS!!!

Enable performance acc. and see if it causes instability, if not keep it enabled. Keep DRAM idler timer and refresh rate on Auto. Enable spread spectrum. I'm not too sure about the Q-fan though... hope this helps :)
 
Welcome to the forums!!! :beer:


Performance Mode under Advanced Chipset: Enabled
Spread Spectrum: Disabled
ICH delayed Transaction: Enabled
MPS Revision 1.4
Idle timer both on auto

At the first screen where your hard drive is. Enable 32-bit data transfer

Jumperfree settings: set to Manual
Set all the voltages to Auto
DRAM Freq: 200
Agp/PCI @66/33
Divider @ 400 1:1 (320 5:4 / 260 3:2)
Performance mode Auto
AGP VDDq voltage: 1.6V

BL....
VFlux
 
pls check ur ram, 1.5GB, u might have stability issues on that one...

1.5GB of ram? 3x512?
 
Back