- Joined
- Apr 30, 2004
Figured I had been lazy long enough, and while the fact that my motherboard's atx and 12v connectors are disadvantageously placed really hindered the two rear intakes, I think it worked out quite well overall. Next motherboard will definately have a right edge atx. Reversing the drives did WONDERS. Check it out, before and after.
And the fruits of a little time and electrical tape:
No fancy behind the motherboard tray routing here, as the PC-60 basically forbids it without lugging out the old dremel again. So its not beautiful, but at least now all the airflow lanes are maximized.
This little clean-up marks the end of this past 6 months modding period, itll sit as is until I get a Mag3, which with these temps probably wont happen for a while.
And the fruits of a little time and electrical tape:
No fancy behind the motherboard tray routing here, as the PC-60 basically forbids it without lugging out the old dremel again. So its not beautiful, but at least now all the airflow lanes are maximized.
This little clean-up marks the end of this past 6 months modding period, itll sit as is until I get a Mag3, which with these temps probably wont happen for a while.
Keep your flow up and temps down... 
