Voltage?

CORSAIR XMS Xtreme Memory Speed Series, Xtra-Low Latency 184-Pin 1GB(512MBx2) DDR PC-3200 w/ Platinum Heat Spreader, Model TWINX1024-3200XLPT - Retail

Model# TWINX1024-3200XLPT Item # N82E16820145523 Specifications:
Manufacturer: CORSAIR
Speed: DDR400(PC3200)
Type: 184-Pin DDR SDRAM
Error Checking: Non-ECC
Registered/Unbuffered: Unbuffered
Cas Latency: 2-2-2-5
Support Voltage: 2.75V
Bandwidth: 3.2GB/s
Organization: two 64M x 64-Bit
Special Features: Plug-n-FragTM Auto-Configuration - Boots automatically using the Xtra-Low latency values of 2-2-2-5
Warranty: Lifetime
My Memory ^,

What should my BIOS be set to for memory voltage? it was at 2.6V but i set it to 2.7V, is that where it should be or did I adjust the wrong thing?

I dont think 3.0 would even hurt that ram unless you have a very porr air-flow system. Chances are with that board you can set it to 2.9 and you should get around 2.96-3.01 volt's flowing thru your ram.

anything over 2.9/3.0 with samsung tccd is probably overkill. most respond to those voltages at max. there is rumour that some of the newer tccd likes additional voltage but as far as i know its not proven yet..

I agree with flapperhead as I forgot (didnt know) those stick's had TCCD chip's on them.