I have an Antec 550TP and so far I like it. The one complaint I have is that there is always warm air blowing out the back of the PSU. Antec has gone to temperature controlled fans to help lower noise.
I don't care about noise.....if I did I would not have installed a Tornado! Is there a way to rewire the fans to make them run full bore 24/7. I figure the cooler I can keep it the better for the PSU and the longer it should last.
My case temp is usally around 20c, but the fan on the bottom of the PSU that sucks air into it sits right next to my SI-97. I don't think that the air that I am pulling into the PSU is very hot as I have a 92mm Tornado on the HS and there is a 120MM exhaust on the back of the case next to the HS also.
Thanks for any input!
I don't care about noise.....if I did I would not have installed a Tornado! Is there a way to rewire the fans to make them run full bore 24/7. I figure the cooler I can keep it the better for the PSU and the longer it should last.
My case temp is usally around 20c, but the fan on the bottom of the PSU that sucks air into it sits right next to my SI-97. I don't think that the air that I am pulling into the PSU is very hot as I have a 92mm Tornado on the HS and there is a 120MM exhaust on the back of the case next to the HS also.
Thanks for any input!