- Thread Starter
- #21
I was about to order some copper flat bar to make my blocks for the pelt(cross drill method) but it will be so much easier if there is a block out there that will cover a 60mm pelt and I cant find any flatbar wider than 2 inches......any ideas on where to pick up a block that big...its the only thing really holding the project up because I can pick up the heater cores monday.
Wow you werent playin around were you? Are those 7" er's runnin full bore and how does it perform with them setup as exhaust pulling, is the airflow pretty even thru the rads or more flow closest to the fans?
Has anyone ever used this type of controller for controlled water temperature?
Wow you werent playin around were you? Are those 7" er's runnin full bore and how does it perform with them setup as exhaust pulling, is the airflow pretty even thru the rads or more flow closest to the fans?
Has anyone ever used this type of controller for controlled water temperature?
Last edited: