I've not put my entry into the poll yet as I've only just got the net in my new house today up and running. Heres some info on my fairly rubbish overclock anyway:
Opteron 144
CABNE 0536
Max case temp = Unknown (will find out later on this evening)
Max overclock = 277x9=2493, Memory = 1024mb of Generic PC3200 @ 208mhz
Default Voltage (!?)
Idle about 35C Load 42+C (needs more research)
Cooling = Cooler Master Hyper 6 HS with Fan on High with OCZ Silver 5+ applied
Motherboard = DFI Lanparty UT nf4 Ultra-D
Power Supply = Sweet (generic really) 650W
1 hour Prime 95 tested (sorry)
I'm running the 310 DFI Bios which I Winflashed.
For some reason, I can run at 2.5 (probably) stable at 2.5ghz, but I cannot boot at 2.6ghz or above (haven't had time to try in between). What happens is my computer resets whilst doing whatever it does when it says "blabhallah DMI... Update"
It simply resets every time I try and boot whilst clocked any higher, even with the most or least volt i can give it. Any help would be grealy appreciated.
1 quick question, should I flash the DMI block when winflashing my BIOS?? (I didn't do this and though i'd killed my pc as it didn't boot the first 3 times after flashing, fine now tho)
I'll read and post a bit more later on tonight