- Joined
- Dec 15, 2004
- Location
- Clermont, Florida
OH OH!!!
OK, replaced the CPU - aplied AS5, put waterblock back, reset CMOS, plugged cables back in and... nothing! Well nothing comes up on my monitor - tried DVI and VGA cables, nothing shows up. The PC seems to come up fine, no beeps, no error codes - checks for the CDROM, HD light comes up but no signal to the monitor... any ideas? Monitor is a DELL 2407 if that makes any difference.
As always, any help is appreciated!!!
<<<<<<<<<>>>>>>>>>>>>
Hello there!
I just got a x2 3800 from the egg today - it will replace my Venice 3000+.
What I was wondering is, what steps do I need to take to ensure that the swap goes smooth? I know I should clear the CMOS before putting the new CPU in but is there anything else I should be doing?
Here are the parts:
Abir AN8 SLI - updated to the latest bios today.
eVGA 6600GT
WD 250gb 16mb and 80gb 8mb
OCZ 520w PSU
2gb Geil PC3200 (4x512)
CPU is watercooled.
Thanks for any info!!!
OK, replaced the CPU - aplied AS5, put waterblock back, reset CMOS, plugged cables back in and... nothing! Well nothing comes up on my monitor - tried DVI and VGA cables, nothing shows up. The PC seems to come up fine, no beeps, no error codes - checks for the CDROM, HD light comes up but no signal to the monitor... any ideas? Monitor is a DELL 2407 if that makes any difference.
As always, any help is appreciated!!!
<<<<<<<<<>>>>>>>>>>>>
Hello there!
I just got a x2 3800 from the egg today - it will replace my Venice 3000+.
What I was wondering is, what steps do I need to take to ensure that the swap goes smooth? I know I should clear the CMOS before putting the new CPU in but is there anything else I should be doing?
Here are the parts:
Abir AN8 SLI - updated to the latest bios today.
eVGA 6600GT
WD 250gb 16mb and 80gb 8mb
OCZ 520w PSU
2gb Geil PC3200 (4x512)
CPU is watercooled.
Thanks for any info!!!
Last edited: