Results 1 to 5 of 5
11-06-06, 10:57 AM #1
Last edited by charmapsyche; 11-11-06 at 10:05 AM.
11-07-06, 12:52 PM #2
I just set the mem. to 1T. Memtest gave me one error in the beginning. Then prime95 only ran for 4min.
I'll try feeding it another volt tonight and see what results I get. I'm at 2.1v right now.
This bios won't let me change the multiplier higher than ten. The built in oc function only goes up to 15 percent. So I'll either have to mod something or start upping the FSB.
11-07-06, 01:48 PM #3
Here's the review for that memory:
In that review Command rate was used 2t. I am not sure about amd and ddr2 but on intel platforms ddr2 runs at 2T command rate.Dell XPS 1330 T8300, 4GB PC6400, LED Monitor, DVD Burner, Intel 4965 wireless, Bluetooth 360, 9cell battery, Windows Vista Ultimate, Remote
Q9550, Gigabyte ex38 ds4, 4GB Corsair Dominator PC8500, evga 8800gt, Corsiar 520w psu, WD 640GB HD, LG Eide Dvd Burner, Antec P182
11-09-06, 12:06 AM #4
Hey thanks meionm! That was a great review!
I've upped the voltage a little.
Now I'm running memtest again.
Just passed the point it had trouble last time.
I don't see a problem with the faster 1T command rate if it's stable.
I wish there was an easy way to change the multiplier in the bios.
Last edited by charmapsyche; 11-11-06 at 10:06 AM.
11-11-06, 10:08 AM #5
I'm going to go back to 2T. I can't get a good torture test out of prime95. Not even w/stock settings right now.
I'm wondering if I should up the volts on the ram?
Last edited by charmapsyche; 11-11-06 at 12:24 PM.