Hey Guys,
New to the board and had a few questions about oc'in and what not... I am using the Pentium D 945 Processor and was using the Asus P5P800-Se I think it was brain fart lol, anyway I could OC to 3.9ghz from 3.4ghz using crappy ddr 266 ram... and would run fine... I opted to take that board back and went with the P5LD2 and went with OCZ GoLD EL XTC 1 gig ram timmings are 4-4-4-12... I can't oc this thing worth crap... I get 3.74 tops at PC2 5700 and that's it.. anything else just doesn't post boot...What exactly is needed other then the typical cooling... Btw when running at 3.0ghz with case open temps was around 25c.... under load 32C...What power supply would be best watts wise? I figure with the OCZ ram this board and 945 everything should OC nicely but in my case not so much lol
Help me out guys!! lol
Thanks
New to the board and had a few questions about oc'in and what not... I am using the Pentium D 945 Processor and was using the Asus P5P800-Se I think it was brain fart lol, anyway I could OC to 3.9ghz from 3.4ghz using crappy ddr 266 ram... and would run fine... I opted to take that board back and went with the P5LD2 and went with OCZ GoLD EL XTC 1 gig ram timmings are 4-4-4-12... I can't oc this thing worth crap... I get 3.74 tops at PC2 5700 and that's it.. anything else just doesn't post boot...What exactly is needed other then the typical cooling... Btw when running at 3.0ghz with case open temps was around 25c.... under load 32C...What power supply would be best watts wise? I figure with the OCZ ram this board and 945 everything should OC nicely but in my case not so much lol
Help me out guys!! lol
Thanks