- Joined
- Feb 25, 2004
- Location
- MA, USA
Is it the 4 hole type or the two hole. I can't tell from the directions.
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
dicecca112 said:they really should update there directions, I hade the 4 hole plate off and was like this doesn't look right
Wowdowner said:the mcw60 can be a ***** to mount, good directions or not.
Actually, it could just be an older image. I have an original MCW60. and it mounts to the card in the same way shown in meionm's pictureMVC said:Meionm, that pic is with the G80 plate. With the standard plate it's a bit more difficult. In order to fit the block on my X1950XT I had to grind the "legs" down a bit because they were too tall and the block didn't contact the chip.
MVC said:Meionm, that pic is with the G80 plate. With the standard plate it's a bit more difficult. In order to fit the block on my X1950XT I had to grind the "legs" down a bit because they were too tall and the block didn't contact the chip.
downer said:the mcw60 can be a ***** to mount, good directions or not.