Results 1 to 6 of 6
Thread: MCP655 enough for this loop?
05-29-07, 10:00 PM #1
MCP655 enough for this loop?
MCW60/Storm/PA120.3/PA120.2? I am thinking of reworking my loop and I really don't know if I want to go to two loops or two pumps for that matter I guess.
Would that be adequate?
05-29-07, 10:06 PM #2
yea 1 mcp655 should be more then enough for that, i think your temps will be fine, worst thing you can do is test it.
05-29-07, 11:00 PM #3
I would say that the 120.2 would be kinda unneeded. That 120.3 should handle a CPU/GPu setup just fine by itself. Just kinda creating more resistance in the loop IMO.
05-30-07, 07:08 AM #4
Yeh I know it will but I am trying to get a water loop(Rads and Blocks at least) that I shouldn't have to upgrade again. Also, I am looking at a few different cases (MM Duality/Horizon, TJ07) and those rads will go in them. My P180 would be hopeless to fit them unless I had some huge external contraption, haha.
05-30-07, 08:37 PM #5
- Join Date
- May 2006
- Anywhere but there
One MCP655 will easily take care of that loop. One MCP655 on P4 can handle the loop shown below ...
05-30-07, 10:11 PM #6
My MCP655 runs through a Storm, EK-FC8800, PA120.2, Microres. Very good temps and flow.