Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    Dec 2001

    CUt off a piece of the HSF?

    I bought a Glaciator II, and it doesn't fit my Soltek DRV2 MB, as there is a capacitory that is about 1/2 inch too close to the upper corner.

    Would it be a bad, bad idea to just grind off enough of the HSF to make it fit? It wouldn't take a whole lot....

    Berkut

  2. #2
    Member plague's Avatar
    Join Date
    Jun 2001
    Location
    NJ
    deja vu....I had the same problem with a glaciator on my board. chopped off a corner and it fits fine now You might lose a little bit of cooling because of the lessened surface area, but i dont think its that big of a deal.

  3. #3
    Moderator/ Silver Paste Taster© Silversinksam's Avatar
    10 Year Badge
    Join Date
    Aug 2001
    Location
    Sunshine State, USA
    Isnt that why GOD created Dremels?


    I recently cut a little off my Alpha pal 15u and it worked out perfectly.

















    Project SLORB Silver Base Blue Orb

    -15 May 2012: On Hiatus helping bees and the planet at the moment

    -You have over 101 signatures and Can't see the classifieds??? Click this link.

    My Heatware

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •