- Joined
- Aug 2, 2007
- Location
- Denmark
- Thread Starter
- #21
I would hope no one spilled soda on his console before selling it to him It happens though. From reading that tutorial, it doesn't sound like you really need to melt the pen. It sounds like you're just getting it hot enough to make it soft and mold around the screw. You really shouldn't be heating it up enough to drip and end up in the cracks around the screws.
never heated it that much, just so its kinda soft so it can be molded, but i gave it a little bit too much on the one screw so its the rests of the pen is sitting ontop of the screw inside the little hole so its hard to get out but just some more hours of scratching with a screwdriver and it should be ok again
but still im so stupid cuz i accedently melted it to much and now one of the screws is stcuk