- Joined
- Sep 19, 2009
- Location
- Crestview, FL
I know this may be a topic for the Ram section, but no one has given an answer that uses this P6T board. On this particular board there is a note in the manual that says:
"Due to INTEL spec definition, X.M.P. DIMMS and DDR3- 1600 are supported for one DIMM per channel only"
what does this mean specifically? is it for XMP OC's or OC's with DDR3-1600mhz ram? I interpolate this as if i was to put "6gigs of Corsair DDR3-1600mHz" (or any 1600mhz) ram then it could only be 2 gig sticks in channels A1, B1 and C1. However, if i wanted 12 gigs of ram, how would it work since i could only place one DDR3-1600 per channel to get?
or am i just not comprehending my reading? I am a newbie to the deeper fundamentals of the inter-workings of computer "tuning" and OC'ing.
"Due to INTEL spec definition, X.M.P. DIMMS and DDR3- 1600 are supported for one DIMM per channel only"
what does this mean specifically? is it for XMP OC's or OC's with DDR3-1600mhz ram? I interpolate this as if i was to put "6gigs of Corsair DDR3-1600mHz" (or any 1600mhz) ram then it could only be 2 gig sticks in channels A1, B1 and C1. However, if i wanted 12 gigs of ram, how would it work since i could only place one DDR3-1600 per channel to get?
or am i just not comprehending my reading? I am a newbie to the deeper fundamentals of the inter-workings of computer "tuning" and OC'ing.