Results 1 to 9 of 9
11-09-09, 11:13 AM #1
Took off my IHS, now how many pounds can I safely load the die?
Took the IHS off my E5200.
How much force could I press on it before it breaks? Yes gonna use a waterblock clamp with spring loading readout.
Wanna max it for minimum BLT (bond line thickness) for maximum cooling! to make this whole de-lidding worthwhile
11-09-09, 11:15 AM #2
You dont really need pressure but good contact.
Less pressure is bad, but too much dont change anything in temp. Ive teste with my apogee GT and even if i push on my GT with my hand really hard, temps dont move, no change.Boulard83 @ OvercloQc.com
BTTB • Gigabyte Z87X-OC • WCed 4770k • 2x8gb Ballistix 1600mhz cas8 • Zotac GTX 780 • Asus Xonar Pheobus
OS Toshiba Q 256gb • Games 2x Agility 4 256gb Raid0 • Corsair HX850 • Tecnofront HWD BenchTable • Asus VE278Q 5760x1080
HTPC • Gigabyte H77m-D3H • G2020 • NT-06 • 2x4gb Patriot Viper 1600mhz • Asus GTX 650 TI • SB Recon3D
X25-m 80gb • Enermax 550w • Lian Li PC-C60B
Server • Asus Z77m PRO • 2500K • NH-C12P • 4x4gb G.Skill Ares 1600mhz
Agility 4 128gb • Corsair CX430M • 2X 1TB Black • 1x 2TB green
KatPat • Gigabyte 990FXA-UD3 • FX-8320 • PH-TC14CS • 2x4gb Patriot Viper 1600mhz • GTS 450 + Accelero L2 Plus
Samsung Evo 120gb • Corsair HX750 • Bitfenix Survivor White • Asus VE247H
11-09-09, 11:21 AM #3
Oh btw could also use some of those AMD rubber feet found on exposed-die chips
11-09-09, 11:31 AM #4
If I'm not mistaken from Intel's spec for LGA775 CPU, the pressure is approx. min. from 25 lbf to max 50 lbf. Just go to Intel web and find for that CPU's datasheet, it should be there.
But that pressure is for cpu with IHS, not at that single cpu die. That stated IHS pressure is evenly spread by the cpu die "and" the ihs's along those black epoxy mark at the green substrate.
Suggesting you to do this HERE to have a really good pressure and to protect the cpu die from cracking/chipped corner when mounting and fastening the cooling gear.
11-09-09, 11:41 AM #5
11-09-09, 11:51 AM #6
i suppose will just have to check out the datasheets for athlonXP with plastic substrate to get an idea...
11-09-09, 01:20 PM #7
- Join Date
- Aug 2003
My buddy chipped 2 corners and an entire edge of his JIUHB xp1700+ back in the day and the bitch still worked fine.
11-09-09, 02:15 PM #8
Before and after temps would be great. I need to do this again, this time however I'll do it to my E5200 as well.The will to live will always outweigh the ability to die
11-09-09, 04:04 PM #9