• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

CM Storm Force Fan 200mm modding advise

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

vincor

New Member
Joined
Aug 10, 2010
I bought a cm storm force 200 from a store and notice that the fan comes with a 2pin head and a molex head.

I assume that the 2pin head are for the Led and the molex head are supposingly for the fan which u can't controll the speed which would be running at 900.

I wanted to hook it up to the fan controller but since it's running on molex with only 2 wires, i believe that there's no way it's gonna be controllable without the rpm wire.

I decided to remove a portion of the fan's sticker which is covering the pcb.

On there , i notice that there's writings and solder points on it.
Led1 with - and + is for led. But i also noticed that there is 3 solder points with indication written as G V and S*where there isnt any wire solder to it*.

G=Ground, V= Voltage and S= ?? sensor which is for the rpm controller?
Could i juz get a any wires and solder onto it and hook the 3 wires to a 3pin head, so that i can be hooked on to a fan controller.
 
Back