• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

FRONTPAGE Hotrod Heatsink: Faster Fans for the Noctua NH-D14

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

Overclockers.com

Member
Joined
Nov 1, 1998
We are overclockers. We are not satisfied with stock. Like our automotive forebears we hotrod our rigs, pushing them to faster speeds. That?s what we do. And when we do it, our chips get hot and we need to cool them off.

Let's say you really want to overclock your CPU, and you want to cool it with air. You know that the Noctua NH-D14 is a very good heatsink, designed for quiet cooling; but you want more. Can you get better cooling from a D14?

... Return to article to continue reading.
 
Last edited by a moderator:
"So it is perfectly compatible with the D14 — after you do a little modding (link)."
Doesn't link to anywhere.
 
Nice writeup. I think the missing link just tells you how to mod it to work with the noctua clips. The clips are made for 140mm hole setup and the other one is setup to attach to 120mm.
 
aHa! Caught! The missing link!!!

OK, here's how you mod it:

Let's start with a normal fan. In this case I have cut the corners out of a Gentle Typhoon. Notice how the clip holder pushes only partly through the flange of the fan:

openingap15corners015.png


Now you need The Tool: a 9/32-inch drill bit. You can also use a 7mm drill bit, but that could be a little tight, so you might use an 8mm drill bit. Here is the GT with The Tool:

openingap15corners016.png


You grip the drill bit in your hand and slowly drill what is called a countersink hole partway through the flange. I suggest you practice on the intake side of a fan to get the feel of how it is done. If you are too strong or don't know when to quit, you can fully enlarge a hole, and that is not what you want to do.

This is what you want to do:

openingap15corners018.png


Note the the enlarged hole -- the countersink -- only goes partway through the flange. The idea is to accommodate the clip holder peg's larger diameter without letting it pull all the way through.

When you are done you will get this:

openingap15corners019.png


You do this for all four corners, and you put the clip ends through these pegs. Now your fan will fit onto a Noctua fin stack with Noctua clips.
 
Back