Hello and greetings,
My Computer won't POST after two weeks of stability. I loaded the default settings last night, then loaded my O.C. profile through my ASUS P6T O.C. profile in the Bios, rebooted about 6-7 times to make sure it would POST (which it did), did not see any black artifacts whatsoever, passed 12.5 hours of stress testing last night with Prime95 and now this morning it DID NOT POST. Below are my System Components and Bios Settings. Please help me find out what is going on with this random instability.
Coolermaster Storm Sniper
I7 930 O.C. to 3.57
Asus P6T Mobo
1000w Rosewill power supply (which is two years old and is only drawing 611w to power everything in my case)
Radeon HD 5970
Soundblaster X-Fi sound card
x4 200mm fans (Intake), x1 140mm fan (Intake), x1 120mm rear exhaust fan
Corsair H100 (with x2 120 mm fans in pull config.)
WD 7200 RPM 1 TB HD
12 Gigs Kingston HyperX Genesis 1600Mhz Ram
BIOS SETTINGS
x21 Multiplier
170 Bclock
1023 DRAM Freq (6-6-6-18 timings)
2046 Unclock Freq
1.325 Vcore
1.35 QPI/VTT
1.1 IOH
1.5 DRAM BUS Freq
All C-state/power saving settings disabled
Load Line Calibration enabled
Everything else is on auto settings
I followed Miahallen's 3 Step Overclocking guide to a T and I still have this random not being able to POST issue after 2 weeks of stability
My Computer won't POST after two weeks of stability. I loaded the default settings last night, then loaded my O.C. profile through my ASUS P6T O.C. profile in the Bios, rebooted about 6-7 times to make sure it would POST (which it did), did not see any black artifacts whatsoever, passed 12.5 hours of stress testing last night with Prime95 and now this morning it DID NOT POST. Below are my System Components and Bios Settings. Please help me find out what is going on with this random instability.
Coolermaster Storm Sniper
I7 930 O.C. to 3.57
Asus P6T Mobo
1000w Rosewill power supply (which is two years old and is only drawing 611w to power everything in my case)
Radeon HD 5970
Soundblaster X-Fi sound card
x4 200mm fans (Intake), x1 140mm fan (Intake), x1 120mm rear exhaust fan
Corsair H100 (with x2 120 mm fans in pull config.)
WD 7200 RPM 1 TB HD
12 Gigs Kingston HyperX Genesis 1600Mhz Ram
BIOS SETTINGS
x21 Multiplier
170 Bclock
1023 DRAM Freq (6-6-6-18 timings)
2046 Unclock Freq
1.325 Vcore
1.35 QPI/VTT
1.1 IOH
1.5 DRAM BUS Freq
All C-state/power saving settings disabled
Load Line Calibration enabled
Everything else is on auto settings
I followed Miahallen's 3 Step Overclocking guide to a T and I still have this random not being able to POST issue after 2 weeks of stability