- Joined
- Aug 28, 2010
According to this guide:
http://www.overclockers.com/high-speed-gentle-typhoon-pwm-mod
Seems like it is possible...
I have this:
I have already cut the wire from the female 3-pin and plan to put the yellow wire from the fan into the male 3-pin. So I should have like in the guide two wires going to the PSU and two on the mobo (RPM sensor + PWM).
Wondering if it is going to work before I pull the trigger for 6x AP-29 AKA 75$.
Plus, I doubt 6 fans will fit on the board, what could I do for this? I just need something to duplicate the mobo signal.
http://www.overclockers.com/high-speed-gentle-typhoon-pwm-mod
Seems like it is possible...
I have this:
I have already cut the wire from the female 3-pin and plan to put the yellow wire from the fan into the male 3-pin. So I should have like in the guide two wires going to the PSU and two on the mobo (RPM sensor + PWM).
Wondering if it is going to work before I pull the trigger for 6x AP-29 AKA 75$.
Plus, I doubt 6 fans will fit on the board, what could I do for this? I just need something to duplicate the mobo signal.