Hello again guys.
I've bought this heatsink that I will drill holes in:
http://www.ebay.com/itm/171015086436?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2648
That I'm going to use in combination with these thermal pads:
http://www.ebay.com/itm/321343194147?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2648
The result will cover the VRM on my card like the area marked on the reference cooler:
Where the screws will provide pressure and good contact. The result will hopefully be close to the stock coolers ability to cool the VRM, and should therefore be a nice supplement to my G10 + H75 cooler. What do you think?
I've bought this heatsink that I will drill holes in:
http://www.ebay.com/itm/171015086436?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2648
That I'm going to use in combination with these thermal pads:
http://www.ebay.com/itm/321343194147?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2648
The result will cover the VRM on my card like the area marked on the reference cooler:
Where the screws will provide pressure and good contact. The result will hopefully be close to the stock coolers ability to cool the VRM, and should therefore be a nice supplement to my G10 + H75 cooler. What do you think?
Last edited by a moderator: