I have been searching high and low for fittings for elbows in a loop and everywhere I look the elbows are for the components and not to extend or "bend" the loop mid tube.
however I did find one fitting that was what I was looking for and it seemed that the manufactures had bad reviews on their other products so I'm not sure that I trust it.
What I am looking for is a 90 degree fit not exactly an elbow but like a curved angle that I can link tubes together instead of bending the tubes I want them all to be straight and clean. Compression fit on both sides. If anyone knows where I can find this or a solution to what I am looking for that would be much appreciated.
however I did find one fitting that was what I was looking for and it seemed that the manufactures had bad reviews on their other products so I'm not sure that I trust it.
What I am looking for is a 90 degree fit not exactly an elbow but like a curved angle that I can link tubes together instead of bending the tubes I want them all to be straight and clean. Compression fit on both sides. If anyone knows where I can find this or a solution to what I am looking for that would be much appreciated.