A quick look at my new memory install

vanibanez · Feb 23, 2015

I replaced my DDR3 1600MHz with some DDR3 1866Mhz. I set the memory to auto in my bios on the system in my sig. When I boot uip the memory shows as 1920Mhz. I have included a pic ffrom CPU-Z:

Is this the correct setup for this memory? It is 2x4GB sticks.

EarthDog · Feb 23, 2015

Your sticks show a timing of 9-10-9-28-37... set that manually.

You have AMD so you can't use the XMP profiles like you can in intell.

Have you raised your bus speed past 200 MHz? Not sure why its shows 959 instead of 933... or a lot closer to that value.

ATMINSIDE · Feb 23, 2015

Looks like you've got a BCLK OC going. Can you post a picture of the CPU tab?

vanibanez · Feb 23, 2015

Yeah the clock is from an overclock I did way-back-when. Never did bother changing it since it ran smooth, here's the cpu:

ATMINSIDE · Feb 23, 2015

That's why the RAM is higher than stock.

vanibanez · Feb 23, 2015

Yeah that's what I thought, also the XMP timings were throwing me off cause they look like the timings I should have. But I realize that's for Intel only.

EarthDog · Feb 23, 2015

What I would do is this...

Try setting the timings manually so they match and see if you are stable.

ATMINSIDE · Feb 23, 2015

EarthDog said:
What I would do is this...

Try setting the timings manually so they match and see if you are stable.

This +1

vanibanez · Feb 23, 2015

I'll give it the old college try, thanks!

A quick look at my new memory install

vanibanez

Member

EarthDog

Gulper Nozzle Co-Owner

ATMINSIDE

Sim Racing Aficionado Co-Owner

vanibanez

Member

ATMINSIDE

Sim Racing Aficionado Co-Owner

vanibanez

Member

EarthDog

Gulper Nozzle Co-Owner

ATMINSIDE

Sim Racing Aficionado Co-Owner

vanibanez

Member

Similar threads