- Joined
- Jun 5, 2009
Hello all,
This is my first loop. I got all the Ek stuff, two Rads, cpu block, combo d5 pump, 2 980gtx blocks and back plates. along with that I gots the uber primochill RED. First, I got the wrong size because the package was marked wrong. It was so tight to put over my barbs. So I waited another week and got the correct size.
I still think it's too tight. Is the tubing supposed to be hard to put on the barbs? Im afraid to break stuff trying to install this tubing.
http://www.performance-pcs.com/prim...ubing-7-16in-id-x-5-8in-od-bloodshed-red.html
These are the barbs I gots.
http://www.performance-pcs.com/ek-acf-compression-fitting-12-16mm-7-16-x-5-8-red.html
if there is any other tube you guys recommend I would like to get some before I start builing.
Thanks,
S.
This is my first loop. I got all the Ek stuff, two Rads, cpu block, combo d5 pump, 2 980gtx blocks and back plates. along with that I gots the uber primochill RED. First, I got the wrong size because the package was marked wrong. It was so tight to put over my barbs. So I waited another week and got the correct size.
I still think it's too tight. Is the tubing supposed to be hard to put on the barbs? Im afraid to break stuff trying to install this tubing.
http://www.performance-pcs.com/prim...ubing-7-16in-id-x-5-8in-od-bloodshed-red.html
These are the barbs I gots.
http://www.performance-pcs.com/ek-acf-compression-fitting-12-16mm-7-16-x-5-8-red.html
if there is any other tube you guys recommend I would like to get some before I start builing.
Thanks,
S.