- Joined
- Sep 13, 2015
So I am thinking of trying to build a dice pot since I have the ability to have parts made (and because I am a cheap SOB). I was hoping for some input on my first design, I've included some different screenshots of the basic design below. My plan is to take a piece of aluminum round stock and turn it to an O.D. of about 3" and then bore the center out to an depth of 10.5" and leave a 1/8" side wall. The bottom will then have a 60 degree taper of 3/4" of an inch leaving a bottom mounting area of 1.5" in diameter. I am then thinking of boring a center hole of 3/4" inch and pressing a 10 inch long copper rod up through the core.I need to do some more detailing on this and make sure it will work but wanted some input before I made it too far. thanks.