- Joined
- Dec 21, 2011
- Location
- Nerwport,NC
WOW sorry must of had my head up my a$$ congrats on taking first on the team. So AMP for you right now long time coming,Nice 
-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
funsoul
- Thread starter QuickFast
- Start date
Thanks everyone!!!
Ran into some trouble (bent pins and a slightly warped 6700k pcb). New board arrived today, need to see if TT or someone else can take a shot at repairing the bent pins in the original board. Now have to figure out the best way to straighten/flatten the cpu pcb, thinking heat gun on low then sandwich the pcb using cardboard (with cutouts for the front/back chip area) and put a pot on top?
Anyway...definitely excited! Hope to still improve a bit (have to fill up the competition boints slots).
Thanks again!!!
PS- And Woomack is definitely the monster contributor!
Ran into some trouble (bent pins and a slightly warped 6700k pcb). New board arrived today, need to see if TT or someone else can take a shot at repairing the bent pins in the original board. Now have to figure out the best way to straighten/flatten the cpu pcb, thinking heat gun on low then sandwich the pcb using cardboard (with cutouts for the front/back chip area) and put a pot on top?
Anyway...definitely excited! Hope to still improve a bit (have to fill up the competition boints slots).
Thanks again!!!
PS- And Woomack is definitely the monster contributor!
Thanks everyone!!!
Ran into some trouble (bent pins and a slightly warped 6700k pcb). New board arrived today, need to see if TT or someone else can take a shot at repairing the bent pins in the original board. Now have to figure out the best way to straighten/flatten the cpu pcb, thinking heat gun on low then sandwich the pcb using cardboard (with cutouts for the front/back chip area) and put a pot on top?
Anyway...definitely excited! Hope to still improve a bit (have to fill up the competition boints slots).
Thanks again!!!
PS- And Woomack is definitely the monster contributor!
Nice work Stefan
My i3 6320 has similar issues. Probably bent PCB is causing it to randomly freeze. PCB was slightly bent but I fixed it. I'm just not sure if it's only PCB as it was working for at least 2 months on the same motherboard fully stable. Issues started when I left it in F@H for a weekend.
I'm missing a lot in competitions as I'm barely submitting anything. I have 8 results and one of them is for current team cup. In general I have 2 submissions in last 2 months or even more but that's other thing
- Joined
- Apr 19, 2012
Keep up the good work! Congrats!
- Joined
- Apr 12, 2014
Nice work Stefan, keep pushing bro
- Joined
- Apr 12, 2014
How's it going? was hoping to see you at the gig,
Too bad you could not make it down
Too bad you could not make it down
- Joined
- Apr 12, 2014
That would be great if they have another gig in this area, still was surprised it ended up in Central PA, you think Washington, Philly or New York ?
I stopped in, not to bench, but to say hello to everyone
Look like everyone was having fun and Stefan grabbed his XTU run while I was there, so that was very cool.
I stopped in, not to bench, but to say hello to everyone
Look like everyone was having fun and Stefan grabbed his XTU run while I was there, so that was very cool.
